Processing 3D punched parts

For deburring and edge rounding 3D punched parts with distortions and bumps we offer discs equipped with flexible SmartFlex sanding strips. These adapt to any unevenness without damaging the actual part.

If the bumps are all on the same side of the workpiece it is possible to use a standard machine with a feed belt conveyor together with flexible sanding strips. However the distortions are often on one side of the workpiece and the edges to be deburred on the other side. In such a case we recommend our DiscMaster SF which works from the top and bottom and uses a conveyor belt with soft rubber rollers instead of a feed belt.

Our machines for processing 3D punched parts with distortions on both sides of the sheet metal

DiscMaster SF
Top and bottom deburring, edge rounding or oxide removal from all angles and directions in working widths of 1000 mm or 1500 mm.
More

MiniSpin
Manual deburring or edge rounding of pipe and tube ends as well as 3D punched parts.
More

Our machines for processing 3D punched parts with distortions on one side.

DiscMaster 2TD
For deburring from all angles and directions, edge rounding, oxide removal or orbital finish with two processing units in a working width of 500 mm.
More

DiscMaster 4TD
For deburring from all angles and directions, edge rounding, oxide removal or orbital finish featuring two processing units in working widths of 1000 mm or 1500 mm.
More

DiscMaster 6TD
For deburring from all angles and directions, edge rounding, oxide removal or orbital finish with three units in working widths of 1000 mm or 1500 mm.
More

BeltMaster K4TD
For finishing and deburring from all angles and directions as well as edge rounding, oxide removal or orbital finish with three processing units in a working width of 1350 mm.
More

SwingGrinder
The Original – for quick and easy deburring and edge rounding.
More

CrossMaster DD
For deburring and edge rounding of smaller parts in working widths of 150 mm or 300 mm.
More

DiscMaster P
For deburring from all angles and directions as well as edge rounding or roughening of aluminium parts in a working width of 1350 mm.
More

DiscMaster 3D
For deburring, edge rounding or roughening of aluminium parts in a working width of 1350 mm or 1850 mm.
More