Oxide Removal
An oxide layer on the side edges usually appears after plasma cutting or laser cutting with oxygen. For better paint adhesion this oxide layer on the inside and outside contours must be removed. It is important to use a system which works from all angles and directions to achive an even result on all contours. LOEWER offers solutions for oxide removal from one or from both sides, in one pass and with 360° processing.
Our machines for oxide removal
DiscMaster 2TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features two units in a working width of 500mm
More
DiscMaster 4TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features two units in working widths of 1000mm, 1500mm or 2000mm
More
DiscMaster 6TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features three units in working widths of 1000mm or 1500mm.
More
BeltMaster K4TD
For finishing as well as 360° deburring , edge rounding, oxide removal or orbital finishing. Features three units in a working width of 1350mm.
More
RotoMaster 1500
For finishing as well as 360° deburring , edge rounding and oxide removal. Edge rounding up to 2 mm radius in 1500 mm working width.
More
DiscMaster SF
For top and bottom deburring, edge rounding or oxide removal from all angles and directions in working widths of 1000mm or 1500mm.
More