Deburring small parts
Small parts pose a challenge for every deburring machine. In particular small parts with holes made of stainless steel or aluminium cannot be held down either with a vacuum system or magnets. When processing with grinding belt units there is the added danger that shooting parts could damage the expensive contact drum or other machine components.
Small parts are often processed by barrel grinding. This will round the edges but will not remove burrs or spatter.The LOEWER disc technology however will do both. It is the comprehensive solution for deburring and edge rounding small parts. Even very small stainless steel parts with a diameter from 20mm and holes in the centre can be processed.
Our machines for deburring small parts without a magnet or vacuum hold-down
CrossMaster DD
For deburring and edge rounding small parts in working widths of 150mm or 300mm.
More
DiscMaster 2TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features two units in a working width of 500mm
More
DiscMaster 4TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features two units in working widths of 1000mm, 1500mm or 2000mm
More
DiscMaster 6TD
For 360° deburring , edge rounding, oxide removal or orbital finishing. Features three units in working widths of 1000mm or 1500mm
More
BeltMaster K4TD
For finishing as well as 360° deburring , edge rounding, oxide removal or orbital finishing. Features three units in a working width of 1350mm.
More