Deburring
When cutting sheet metal burrs usually appear. Depending on the cutting process used these can vary from severe to rather light. Punched parts can be deburred using a brush tool only. However this will lead to edge rounding at the same time. Laser- or plasma-cut parts often have a higher burr which means that a more agressive tool is needed to remove them. This in turn leaves a sharp secondary burr which subsequently has to be rounded. LOEWER offers a wide range of solutions for deburring precision-cut parts as well as 3D punched parts.
Our machines for deburring
DiscMaster 2TD
For deburring from all angles and directions as well as edge rounding, oxide removal and orbital finish. Features two units in a working width of 500mm.
More
DiscMaster 4TD
For deburring form all angles and directions as well as edge rounding, oxide removal and orbital finish. Features two units in working widths of 1000mm or 1500mm.
More
DiscMaster 6TD
For deburring from all angles and directions as well as edge rounding, oxide removal and orbital finish. Features three units in working widths of 1000mm or 1500mm.
More
BeltMaster K4TD
For finishing and deburring from all angles and directions as well as edge rounding, oxide removal or orbital finish. Features three units in a working width of 1350 mm.
More
RotoMaster 1500
For finishing as well as 360° deburring , edge rounding and oxide removal. Edge rounding up to 2 mm radius in 1500 mm working width.
More
CrossMaster DD
For deburring and edge rounding of small parts in working widths of 150mm or 300mm.
More
CrossMaster Dx2
For top and bottom deburring and edge rounding in one pass in a working width of 200mm.
More
SwingGrinder
The Original –Â semi-automatic solution for quick and easy deburring and edge rounding.
More
DiscMaster SF
For top and bottom deburring, edge rounding and oxide removal from all angles and directions in working widths of 1000mm or 1500mm.
More
DiscMaster 3D
For deburring, edge rounding or roughening of aluminium parts in a working width of 1350mm or 1850mm.
More
DiscMaster P
For deburring, edge rounding or roughening of aluminium parts from all angles and directions in a working width of 1350mm.
Mehr
MiniSpin
For manual deburring or edge rounding of pipe and profile ends as well as 3D punched parts.
Mehr
BeltMaster 600
For deburring and edge rounding of precision-cut parts in a working width of 600mm.
Mehr