Straight-Line Finish
A decorative, graining finish can be achieved using abrasive belt units or brush drums. This typical graining finish is common on stainless steel sheet metal or rectangular tubes. Depending on the surface finish required, between one ond four units can be used in one pass. LOEWER offer a range of models for wet and dry processing.
Our machines for a straight-line finish
BeltMaster K4TD
For finishing as well as 360° deburring, edge rounding, oxide removal or orbital finishing. Features three units in a working width of 1350mm or 1500mm.
More
RotoMaster 1500
For finishing as well as 360° deburring, edge rounding and oxide removal. Edge rounding up to 2mm radius in 1500mm working width.
More
BeltMaster 300
For deburring, edge rounding and finish in a working width of 300mm.
More
